![]() ![]() ![]() I used Macrium Reflect to do the cloning inside windows, and the used Partition Magic to change the partition size also within windows, then set the new drive as the active drive, disconnected the old drive, and rebooted. I figured it was changing the partition size while the drive was the main drive that caused the issue, even though it was done outside of Windows, so I figured I should clone the drive, then immediately resize without rebooting so I needed a cloning program that ran it in windows. This operation was also performed outside of windows, and after rebooting, I found that my OS installation was hosed.blue screen on startup. So I rebooted with the new drive then tried using Mini tool Partition Wizard to resize the partition to fill up the rest of the drive. Acronis does the cloning outside of windows and immediately makes the new drive the boot drive. So I used Acronis to make an exact clone of the 180GB drive and figured I would just increase the size of the partition afterwards. In my case, I wanted to increase the size of the OS partition and keep the size of the boot and recovery partitions the same as my 180GB drive. ![]() I don't know if this is a limitation of the cloning process but since it does allow you to make the partitions proportionally bigger when cloning, I'm guessing it should be possible. Recently I bought a Crucial MX200 500GB drive and I thought moving all my data from my old 180GB SSD would be a simple matter of cloning using the provided Acronis True Image, however, it wasn't as simple as I thought it would be.įirstly, Acronis does not allow you to resize the partitions to your liking.
0 Comments
Leave a Reply. |